GREENER MECHANICAL HUDSON VALLEY

tekmar Controls are typically used in hydronic (water distributed) heating systems to increase the level of comfort and reliability. You will often find tekmar controls in buildings that have in-floor heating installed. The addition of control for domestic hot water, forced air heating, ventilation and cooling provides for an all-inclusive system. Contractors select integrated components that range from thermostats and sensors to outdoor reset controls and automatic snow & ice detectors; depending on the individual system design.

The overall operation of a heating, ventilation and cooling system can be optimized by a tekmar Outdoor Reset Control. Outdoor Reset Controls include Energy Saving features that provide a return on investment with lower heating bills, while reducing impact on the environment. These controls specialize in operating the system at maximum efficiency while maintaining priority for other devices when needed. The type of outdoor reset control selected by a contractor will depend on the overall system design.

tekmar Thermostats are available in both non-programmable and programmable types. Many offer a display-screen user interface with button operated menus. In tekmarNet®4 systems, thermostats can share outdoor temperature, system status and scheduling information with each other.

Various tekmar sensors are used to measure indoor, outdoor, in-floor, in-slab, piping, duct and domestic hot water temperatures. They are a critical component in a tekmar system, providing real-time temperature status so that controls and thermostats can optimize system operation as a whole

LITERATURE DOWNLOADS

http://tekmarcontrols.com/literature.html

If a heating system does not know if it is a cool autumn night or the coldest winter day, it works as if it's always the coldest day of the year and heats the water to a maximum temperature. Having this hot water in the distribution piping when it's not needed results in stand-by heat loss. By adding a tekmar Outdoor Reset Control that works alongside of your boiler and thermostat, you may see energy savings of up to 30%.

WHAT YOU NEED TO KNOW

As the disparity between indoor
& outdoor temperature increases,
so does the rate of heat transfer from
hot areas to cold.
A building's heat loss or gain depends considerably on two things:

Outdoor air temperature
(as temperature difference between the exterior and interior increases, so does the rate of heat transfer)
The building envelope's resistance to heat transfer
(a higher R value in building materials will impede the transfer of heat)
While a control will not impact the R-Value of building materials, it can ensure that the system does not waste heat by exceeding current requirements. Providing only the required amount of heat reduces fuel consumption, creating less pollution while saving you money.

How an Average Heating System Works...

When the interior air temperature drops below the thermostat setting, a signal is sent to the boiler to turn on. Unfortunately, the thermostat only tells the boiler to turn on when the house is too cold or turn off when the house is too warm. There is no in-between.

How many miles per gallon would your car get if the only method of controlling your speed was to accelerate until you're going too fast, and then apply the brakes?
How Your Heating System Should Work...

You adjust your car's gas pedal to maintain a comfortable driving speed and good fuel economy. Why not the same with your heating system? By adding a tekmar Outdoor Reset Control, heating system water temperatures are adjusted to maintain comfort and improve system efficiency.

http://tekmarcontrols.com/savings.html

FEATURES BENEFITS CLICK ABOVE

CLICK  PIC FOR MORE INFO ON TEKMAR

CALL TODAY FOR YOUR IN HOME ANALYSIS...

HUDSON VALLEY , ORANGE,  ULSTER, SULLIVAN COUNTIES

GREEN MECHANICALS....HIGH EFFICIENCY, ECO FRIENDLY HVAC, CONTROLS